Purpose
This guide is intended to show the simplest way to change the tablet in your vehicle from a 2020 to a Connect.
The only hardware that needs to be replaced is:
- 2020 Dock
- 2020 Tablet
No other hardware needs to be replaced. No software needs to be updated. Your Ground Traffic Control and Zonar Logs software will work seamlessly with both 2020 and Connect tablet.
Procedure
Removing the 2020 Dock
Remove the 2020 tablet from the dock.
Loosen the RAM mount until the ball joint can be removed from the arm.
You may need to squeeze the base of the arm to allow the ball joint to be removed.
Disconnect the 14-pin connector from the bottom of the 2020 dock.
You will need to push the small lever on the back while pulling the connector out.
Remove the 4 screws holding down the ball joint from the back of the dock.
Set aside the 2020 and dock, but retain the screws and ball joint.
Attaching the Connect Dock
Retrieve the Connect dock. Attaching it will proceed in reverse order from removing the 2020 dock.
Attach the ball joint to the back of the Connect dock with the 4 screws available.
Connect the 14-pin connector to the Connect dock.
Push the ball joint back into the RAM mount arm.
You may need to squeeze the base of the arm to re-attach the ball joint.
Tighten the RAM mount until the dock is stable.
Place the Connect into the dock. Push the top of the Connect back until it snaps into place.
Securing the Connect
The Connect dock comes with a levered latch on top. Once the Connect is pressed firmly into the dock, close the latch.
The dock should not move while the Connect is secured. Tighten the RAM mount as necessary.